How to Change Hyundai Elantra Abs Sensor

How to Change Hyundai Elantra Abs Sensor: (ABS) Wheel Speed Sensor Front Right (Front-RH, Range/Performance Intermittent).

Scanner tool screen connected to a Hyundai Elantra showing a faulty front right abs sensor..
Hyundai Elantra Abs Sensor Replacement

Symptoms of Failing ABS Sensor Hyundai Elantra

Intermittent and unnecessary ABS activation on low speed and dry conditions, intermittent trouble abs light illumination in dashboard.

Hyundai Elantra front right abs sensor and front wheel hub.
Hyundai Elantra Abs sensor location

How to Change Hyundai Elantra Abs Sensor: Changing right front abs sensor fixed this problem. 2014 Hyundai Elantra Gls, automatic transmission. Sensor costs about $100 or so depending where you buy it and is available at most auto parts stores.

Removal and installation should take about an hour and will require a 10mm and 12mm socket/ratchet, flat and Phillips screwdriver.

Front right wheel has to be removed. Lift your used car and support it on jack stands. Do not work on vehicle supported only by a standard vehicle jack. Have parking brake engaged.

Abs sensor is secured in place with a 10mm bolt. Remove bolt and pull abs sensor out.

Hyundai Elantra Abs Sensor wire clip on front strut mount.
Hyundai Elantra Abs Sensor Removal

Sensor might be seized, use a flat screwdriver to slowly remove it. Next, remove 12mm bolt securing sensor wire to strut mount and 10mm bolt in chassis (image below).

Hyundai Elantra Abs Sensor wire positioning on car frame clips.
Abs sensor wire mounts

Wheel well lining has to be removed to change Hyundai Elantra Abs sensor. Abs sensor plug is located underneath wheel lining on top part of fender.

Hyundai Elantra with right front wheel well lining removed.
Hyundai Elantra Abs sensor connector location

Hyundai Abs Sensor Removal

Remove well lining’s bottom Phillips screws (three screws) and top plastic clips. Pull wheel liming aside towards the front of vehicle. Do not completely remove wheel lining, only rear part of it where abs sensor is located.

Hyundai Elantra abs sensor electrical connector location on top part of fender.
Hyundai Elantra Fault Code C1204

Unplug Hyundai Elantra abs sensor electrical connection by pressing on connector tab (image below, red arrow).

Hyundai Elantra without Wheel well lining and 
abs sensor electrical plug.
Hyundai Elantra Abs sensor connector

Hyundai Elantra Abs Sensor Installation

Installation is just reversal of removal, start from top and plug new abs sensor electrical connection, install wheel well lining and proceed to install all screws and bolts.

Push new abs sensor in place and install 10mm bolt, do not over tighten. Install front wheel. Abs light should go out by itself (might require a short drive), no need to remove codes with a scanner.

(If you are also looking for a fast and easy solution to sell your car, more here on “How To Sell Your Car Fast” in Ontario).

Comments: If you have any questions or suggestions related to this post or Used Car Toronto in general, don’t hesitate to use comment section below.

You may also like...

1 Response

  1. NIKOLAY TIKHOVSKIY says:

    Connector ABS Sensor Wire

Leave a Reply

Your email address will not be published. Required fields are marked *